In an effort to improve the gas output and portability of the original hydrogen fuel cell, my friend Joseph and I have taken on ProjX funding to complete our new design. Each plate has a rubber gasket between them.
Note to self: never cut a gasket out in a laser cutter before cleaning it off, the ashy bits get everywhere
Subscribe to:
Post Comments (Atom)
Getting a handle on LTspice
One of my skills as an engineer is having a modicum of knowledge about circuitry although I do not have an electrical engineering degree. ...


-
I have been spending some of my spare time learning the ropes of Amazon Web Services (AWS). This service is great for handling large scale n...
-
I have been meaning to open this for a while now. This PCB came off an old smoke detector I found in a pile of electronic trash. A lot of...
-
My friend David and I turned on a Stirling engine on Friday. The engine is a Cryotel CT from Sunpower in Ohio. The device is capable of br...

No comments:
Post a Comment