Framing my License

 I finally got around to putting my NRC license in a hard plastic frame. This slice of paper sure is a neat thing. The craftsmanship and graphic quality is top notch. I don't know if I can say the same about the acrylic I used to slip it between. I used a cyanoacrylate super glue to bind the two acrylic sheets together with the paper in-between. Some seeped into the paper fibers. Lastly, I put a magnet on the back and set the whole thing on the door of my fridge.


-

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

The Winds Blow a Little Colder

  The mushrooms are popping free from the dirt and the temperature has dropped quite a bit these past two weeks. Fall is here and life is go...

  • Unpacking an Old Smoke Detector
     I have been meaning to open this for a while now. This PCB came off an old smoke detector I found in a pile of electronic trash. A lot of...
  • Static Hosting with AWS
    I have been spending some of my spare time learning the ropes of Amazon Web Services (AWS). This service is great for handling large scale n...
  • Stirling Engine turns on and gets cold
    My friend David and I turned on a Stirling engine on Friday. The engine is a Cryotel CT from Sunpower in Ohio. The device is capable of br...