Replacing Guitar Nut

 This morning I used a 3D printed piece of plastic to bring my guitar back to life. The small piece at the top of the neck which holds the strings of the guitar in place is called the nut. It's not to complicated and fairly easy to make an STL file.

Working on more DAQ boards

The broken nut

-

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

The Winds Blow a Little Colder

  The mushrooms are popping free from the dirt and the temperature has dropped quite a bit these past two weeks. Fall is here and life is go...

  • Unpacking an Old Smoke Detector
     I have been meaning to open this for a while now. This PCB came off an old smoke detector I found in a pile of electronic trash. A lot of...
  • Static Hosting with AWS
    I have been spending some of my spare time learning the ropes of Amazon Web Services (AWS). This service is great for handling large scale n...
  • Stirling Engine turns on and gets cold
    My friend David and I turned on a Stirling engine on Friday. The engine is a Cryotel CT from Sunpower in Ohio. The device is capable of br...