Branching out to KiCAD

I am learning how to use KiCAD. One of two major PCB layout software packages (the other being EAGLE). I appreciate the documentation I am able to find online for KiCAD and the open-source community is a good place to helpful tips.
-

1 comment:

Subscribe to: Post Comments (Atom)

The Winds Blow a Little Colder

  The mushrooms are popping free from the dirt and the temperature has dropped quite a bit these past two weeks. Fall is here and life is go...

  • Unpacking an Old Smoke Detector
     I have been meaning to open this for a while now. This PCB came off an old smoke detector I found in a pile of electronic trash. A lot of...
  • Static Hosting with AWS
    I have been spending some of my spare time learning the ropes of Amazon Web Services (AWS). This service is great for handling large scale n...
  • Stirling Engine turns on and gets cold
    My friend David and I turned on a Stirling engine on Friday. The engine is a Cryotel CT from Sunpower in Ohio. The device is capable of br...